Control panel hole sizes
Jump to navigation
Jump to search
Taken from the following thread by csa3d http://forum.arcadecontrols.com/index.php?topic=71031.0 -FhM
| Component | Hole Size Required | Recommended Tool | Additional Notes |
| Push Button Holes | |||
| Happs Standard Pushbutton | 1 1/8" | Fostner Bit, Hole Saw | |
| Happs Mini Pushbutton | 1/2" | Drill Bit | fits styles A, B, and C |
| Happ Sub-Miniature Pushbuttons | 5/16 | ||
| Leaf Buttons | 1 5/32 | Fostner Bit, Hole Saw | 1 5/32 is perfect but 1 3/16 will work |
| Atari Volcano Pushbutton | 29/64" | standard drill bit | |
| Standard Sanwa/Seimitsu buttons | 30mm | ||
| Small Sanwa buttons | 24mm | ||
| Trackball Center Holes | |||
| Betson 2.25" Trackball (lip exposed) | 2 1/4" | Hole Saw | hole needed for lexan overlay |
| Betson 2.25" Trackball (ball exposed only) | 1 15/16"" | Hole Saw | hole needed for lexan overlay |
| 3" Happs Trackball Standard (expose lip) | 3" | Hole Saw | Hole needed for lexan overlay |
| 3" Happs Trackball Highball (expose lip) | 3 1/4" | Hole Saw | hole needed for lexan overlay |
| 3" Happs Trackball Standard (expose only ball) | 2 7/8" | Hole Saw | hole needed for lexan overlay |
| 3" Betson Imperial Trackball (expose lip) | 2 7/8" | Hole Saw | hole needed for lexan overlay |
| Joysticks | |||
| UltraStick360 Joystick | 1 1/8" | Fostner Bit, Hole Saw | Hole needed for stick to poke up through bottom mount |
| Suzo (STC) 500 Joystick | 1 3/4" & 1 1/8" holes | Fostner Bit, Hole Saw | Holes needed for stick to poke up through bottom mount. Installation Details |
| Spinners | |||
| SlickStick Tornado Spinners | 3/8" | Drill Bit | only shaft pokes out |
| GGG TurboTwist 2 Spinner | 1 1/8" | Fostner Bit, Hole Saw | fits in a standard button hole |
